Welded Galvanized Elbow Hot Dip Galvanized Elbow 150 100 80 65 5040 Carbon Steel Elbow 90 ° Outer Diameter DN50

Welded Galvanized Elbow Hot Dip Galvanized Elbow 150 100 80 65 5040 Carbon Steel Elbow 90 ° Outer Diameter 60*4=DN50
Elbow is a common connection pipe fittings in plumbing installation. It is used to connect the pipe at the corner and change the direction of the pipe.
Other names: 90° elbow, right Angle elbow, love elbow, stamping elbow, pressing elbow, mechanical elbow, welding elbow, etc.
Use: connect two pipes with the same or different nominal diameters to make the pipes turn 90°, 45°, 180° and various degrees.
Bending radius less than or equal to 1.5 times of pipe diameter belongs to elbow, and greater than 1.5 times of pipe diameter belongs to elbow.

1. Since most pipe fittings are used for welding, in order to improve the welding quality, the end parts are beveled, with a certain Angle and a certain edge. This requirement is also strict. The surface quality and mechanical properties are basically the same as pipes. For the convenience of welding, the pipe fittings are of the same steel grade as the pipe to be connected.
2. All pipe fittings should be surface treated. The iron oxide on the inner and outer surfaces should be sprayed off by shot peening, and then coated with anticorrosive paint. This is for export needs, moreover, in order to facilitate transportation to prevent corrosion and oxidation, we must do this work.
3, is the packaging requirements for small pipe, such as export, you need to do wooden cases, about 1 cubic meter, the number of elbows in the box can not exceed about a ton, the standard allows the set, that is, a large set of small, but the total weight generally can not exceed 1 ton. For large pieces y needs to be packed individually, like 24 "must be packed individually. Another is the packaging mark, the mark is to indicate the size, steel number, batch number, manufacturer's trademark, etc.